New Device will show up with a nine digit number and below that you will see your camera model. Scan the QR code that is displayed on your computer screen.
In the account you will go to the circle in the top right to access the QR Code Scanner.If Enable is not checked for Platform Access, click that and select save.Īdding the Camera to the Cloud P2P Account In Advanced Settings go to Platform Access and make sure your phone or tablet is ready and logged into the Cloud P2P account that was created in the previous section.Save that and go to Advanced Settings under Network.In the "Preferred DNS Server" type "8.8.8.8," and in "Alternate DNS Server" type "8.8.4.4." At the bottom of the Network tab, you will find Preferred and Alternate DNS Server.Go to the Configuration menu on the camera's interface, then to the Network tab.If you are in need of the firmware to update your camera please check our website for the latest firmware.Īfter this, your camera should be up to date and you can now add the camera to Cloud P2P by following these steps: You can locate the firmware under configuration, head over to system then system settings. Your camera will need Firmware Version 5.4.1 or above in order for you to access the camera on your Cloud P2P account. For this demonstration I am using camera model NSC-204-BT.īefore you can add the camera to your Cloud P2P account you will need to check and make sure you have the correct firmware. We’re going to start off with using Cloud P2P on an IP camera. Assigning an IP Address to your IP Camera.This guide assumes that you have already configured your IP address for your camera or NVR/DVR, if not and you need some help, please refer to this guide. Enter in that verification code that was sent to your email and you will be taken to set up a username and password for the account.Ĭongratulations! You have just set up your Cloud P2P account!.
You will receive an email with a verification code to start your account.
0 kommentar(er)
